- +91 9024156475
- info@zinbal.com
Showing 1–20 of 27 results
Shaft length: 7 mm
Motor Design: L-Shaped
Shaft Diameter: 5.5 mm
Size: 55 x 48 x 23 mm.
Operating Voltage: 3 to 12V
Current (without loading): 40-180mA
RPM: 150 rpm
Output Torque: 0.8 kg cm.
RPM: 150.
Operating Voltage: 12V DC
Gearbox: Attached Plastic (spur)Gearbox
Shaft diameter: 6mm with internal hole
Torque: 2 kg-cm
No-load current = 60 mA(Max)
Load current = 300 mA(Max).
Shaft length: 7 mm
Shaft Diameter: 5.5 mm
Size: 55 x 48 x 23 mm.
Operating Voltage: 3 to 12V.
Current (without loading): 40-180mA.
RPM: 150 rpm.
Output Torque: 0.8 kg cm.
RPM: 300.
Operating Voltage: 12V DC
Gearbox: Attached Plastic (spur)Gearbox
Shaft diameter: 6mm with internal hole
Torque: 1 kg-cm
No-load current = 60 mA(Max)
Load current = 300 mA(Max).
1 channel relay board
Operating voltage 5V
Maximum current: 20mA
Relay contact current capacity at AC250V: 10A
Relay contact current capacity DC5V: 10A
Power indicator light
Control Indicator light
Trigger input voltage 3.3V – 5V
Two separate LEDs to indicate relay on/off
Back EMF Protection
Two LEDs to indicate when the relay is on.
Works with logic level signals from 3.3V or 5V devices
Module with diode current protection, short response time
AC control voltage: 250V at max 10A
DC control voltage: 30V at max 10A
Plastic Parts Material ABS
Maximum Voltage(V) 300
Maximum Operating Current (A) 3 – 5
Allowed Wire Size (AWG) 29 ~ 20
Dimensions 170mmx64mm
Wheel Size: 65mm x 26mm
WEIGHT: 20.00g
The geared DC motor will operate on voltages between 3-9VDC.
Plastic Yellow Rim
Robot Wheel is suitable for all BO motors
Wheel Diameter – 70 mm
Wheel Width – 20 mm
Shaft Diameter – 6 mm
Weight: 33gm
Working voltage: DC 4.8-6V
Provides 3 modes to check servos and ESCs
You can adjust the knob to different speeds and check the response time in manual mode.
In neutral mode, the servo returns to the neutral point.
Automatic "window wiper" mode causes the servo to rotate through the widest possible angle like a window wiper.
Connect up to 3 servos simultaneously
This is a single-row 40-pin female header/pin header. You can cut it to your desired size with a wire cutter. The standard pitch for this header is 2.0mm. Technical Specs
Number of Pins: 40
Pin Spacing: 2 mm
Strip Length: 80.60 mm
Strip width: 2.49 mm
Strip Height: 6.8 mm (with contact Points)
These are 40-pin 20cm female-to-female jumper wires. A very flexible and easily detachable cable to the number of wires per your requirements. It has a female connector on each end. It also supports pin headers with a 2.54mm pitch. Technical Specs
Cable Type : Female to Female
Number of Pins: 40
Length : 200mm
Supply Voltage: 4.5V to 36V
Output Current: 600mA per channel (continuous)
Number of Channels: 2 H-bridge channels
H-Bridge Configuration: Bidirectional control
Package Type: DIP
Supply Voltage: 5V to 35V
Output Current : 2A per channel (continuous)
Number of Channels : 2 H-bridge channels
H-Bridge Configuration : Bidirectional control
Maximum Power Dissipation : Up to 25W (Tcase = 75°C)
Maximum Frequency : 100kHz
Enable and Status Pins : Available for each channel
This is a single-row 40-pin male header/pin header. You can cut it to your desired size with a wire cutter. The standard pitch for this header is 2.0mm. Technical Specs
Number of Pins: 40
Pin Spacing: 2 mm
Strip Length: 80.60 mm
Strip width: 2.49 mm
Strip Height: 6.8 mm (with contact Points)
These are 40-pin 20cm male-to-female jumper wires. A very flexible and easily detachable cable to the number of wires per your requirements. It has a 1-pin male connector and a 1-pin female connector on each end. It also supports pin headers with a 2.54mm pitch. Technical Specs
Cable Type : Male to Female
Number of Pins: 40
Length : 200mm
These are 40-pin 20cm male-to-male jumper wires. A very flexible and easily detachable cable to the number of wires per your requirements. It has a male connector on each end. It also supports pin headers with a 2.54mm pitch. Technical Specs
Cable Type : Male to Male
Number of Pins: 40
Length : 200mm
Plastic Parts Material ABS
Mounting Holes M2
Maximum Operating Current (A) 3 – 5
Allowed Wire Size (AWG) 29 ~ 20
Dimensions 46mmx36mm
Operating Voltage : 3 ~ 6V
Operating Current: 130 ~ 220mA
Flow Rate : 80 ~ 120 L/H
Maximum Lift : 40 ~ 110 mm
Continuous Working Life : 500 hours
Up to 480 Mbps data transfer rate.
USB Type: Type-A to Mini-B.
Exclusively designed for Arduino boards.
Zinbal EdTech Private Limited
S4, Sector 5, Pratap Nagar, Sanganer, Jaipur, Rajasthan 302033
Copyright © 2023, All Rights Reserved. | Zinbal EdTech Pvt. Ltd.